Change device password
Your PiAware device is on the Internet, so although it is likely behind your home router (NAT), it is still a good idea to change the pi user's password from the default password (flightaware).
- Login to the device with the username "pi" and password "flightaware".
- "passwd" टाइप करें और अकाउंट का पासवर्ड बदलने के लिए निर्देशों का पालन करें।
Enable SSH access
- For security reasons, SSH access is disabled by default on new PiAware SD card installs, starting with version 3.3. To enable SSH, create an empty file on the /boot partition of the SD card with the filename of "ssh" only (no file extension). When this file is present, SSH will be automatically enabled.
Edit the configuration file using Command Line
The fully pre-configured FlightAware PiAware 3 SD card includes a default configuration which can either be edited directly or alternatively saved to a USB flash drive or other USB storage. If the USB storage device is connected to the Raspberry Pi when the Raspberry Pi is booted then the USB device’s configuration file will be used. The SD card image Zip file also includes a sample configuration file (piaware-config.txt). If the Raspberry Pi is subsequently rebooted without the USB flash drive or other storage, PiAware will revert to the config file on the SD card. Setting the configuration via USB storage device is only supported on the PiAware 3 SD card image install.
-
Use the "piaware-config" utility to view and change settings. Run "piaware-config <setting> <value>" to make changes. Run "piaware-config" to show the current configuration settings.
-
Edit /boot/piaware-config.txt to make configuration changes, using an editor of your choice (e.g. "sudo nano /boot/piaware-config.txt").
-
For package-based installs, use piaware-config or edit /etc/piaware.conf.
If it is not convenient to remove the SD card and command line access is not possible. an external USB flash drive containing a piaware-config.txt file can be attached to the Pi. Settings in that file override any settings on the SD card. The flash drive should be attached before powering on the Pi and should remain connected while the Pi is running.
To ensure that all configuration changes take effect, please restart/reboot the Raspberry Pi after making changes.
Expand Filesystem for large SD cards
यदि आपके पास बड़ा SD कार्ड है तो आप लॉगिन करके और यह टाइप कर अपनी डिवाइस पर उपयोग योग्य स्पेस को बढ़ा सकते हैं :
sudo raspi-config
इसके बाद, मेनू से "फाइल सिस्टम को विस्तारित करें" चुनें जब पूरा हो जाए तो मेनू से बाहर आएँ और यह टाइप करें :
sudo reboot
यह डिवाइस अब रीबूट होगी और इसीके साथ प्रक्रिया पूर्ण होती है।
Access PiAware via Command Line
आप लॉगिन करके और यह टाइप कर PiAware के स्टेटस को जाँच सकते हैंं :
sudo piaware-status
आप यह टाइप कर PiAware रीस्टार्ट कर सकते हैं:
sudo systemctl restart piaware
For details on all available configuration options, please see our Advanced Configuration documentation.